Fast sexdating

This is a typical dome with a pigtail with a power and Ethernet jack that comes out the back of the camera plus it has a separate pigtail for alarm and audio.

To make the install clean, you’ll need to drill a whole about 1″ diameter to slip the jack inside.

What I like to do is make them sequential, for example, I would make the HTTP port 8400, RTSP port 8402, HTTPS port 8401 and SDK port 8402 and then in my router I would setup port forward range from 8400-8403.

Makes it easier to track which ports go with which camera.

I’ll go over some of the setup screens of interest.

After setting the IP address in SADP, you can change it again under Network, but since that’s done, the next step may be configuring the ports if you want to access the cameras from the internet.

The way it’s mounted is there’s a cast metal plate that attaches to the wall, eave, ceiling and then you attached the camera base with a few machine screws and then attach the dome with the included tool.

The speaker volume control in the lower left, the microphone on/off icon in the lower right.You reach this from the Playback tab and it has a calendar on the right to select a date.There’s a timeline below the image and you can adjust the timeline period using the plus and minus signs.This controls the frames per second setting under Video/Audio, for example, set at 50hz you can set the max frame rate to 25fps max for 1080P, set at 60hz allows you to set the max rate to 30fps.Another unique feature on this camera is the micro SD card slot and ability to play back recordings.

Leave a Reply